An experimental study on the fire characteristics of new and aged building wires using a cone calorimeter

Journal of Thermal Analysis and Calorimetry - The fire behavior of one flame-retardant PVC cable used as building wire is investigated in this work. Bench scale tests were performed using a cone...     

Comparative pharmacokinetic study of four major bioactive components after oral administration of Zhi‐Zi‐Hou‐Po decoction in normal and corticosterone‐induced depressive rats

A highly selective and efficient LC–MS/MS method was developed to determine the plasma concentration of magnolol, hesperidin, neohesperidin and geniposide following oral administration of Zhi‐Zi‐Hou‐Po decoction in normal and depressed rats. Plasma samples were pretreated by protein precipitation with methanol. Chromatographic separation was performed on an XTerra^® MS C₁₈ column using a gradient elution with a mobile phase composed of acetonitrile–0.1% aqueous formic acid. The proposed method was validated to be specific, accurate and precise for the analytes determination in plasma samples. The calibration curves displayed good linearity over definite concentration ranges for the analytes. The intra‐ and inter‐day precision of the proposed method at three different levels were all within <11.13% and the relative errors ranged from ?8.46 to 8.93%. The recovery of the four compounds ranged from 82.72 to 89.08% and no apparent matrix effect was observed during sample analysis. After full validation, the established method was successfully applied for comparing the pharmacokinetics of four components between normal and depressed rats. The results showed that the AUC and C_max of four analytes in depressed rats were significantly different from those in normal rats and might provide helpful information to guide the clinical use of Zhi‐Zi‐Hou‐Po to treat depression.     

Cetyl‐alcohol‐reinforced hollow fiber solid/liquid‐phase microextraction and HPLC–DAD analysis of ezetimibe and simvastatin in human plasma and urine

A new cetyl‐alcohol‐reinforced hollow fiber solid/liquid‐phase microextraction (CA–HF–SLPME) followed by high‐performance liquid chromatography–diode array detection (HPLC–DAD) method was developed for simultaneous determination of ezetimibe and simvastatin in human plasma and urine samples. To prepare the CA–HF–SLPME device, the cetyl‐alcohol was immobilized into the pores of a 2.5 cm hollow fiber micro‐tube and the lumen of the micro‐tube was filled with 1‐octanol with the two ends sealed. Afterwards, the prepared device was introduced into 10 mL of the sample solution containing the analytes with agitation. Under optimized conditions, calibration curves plotted in spiked plasma and urine samples were linear in the ranges of 0.363–25/0.49–25 μg L^?1 for ezetimibe/simvastatin and 0.193–25/0.312–25 μg L^?1 for ezetimibe/simvastatin in plasma and urine samples, respectively. The limit of detection was 0.109/0.174 μg L^?1 for ezetimibe/simvastatin in plasma and 0.058/0.093 μg L^?1 for ezetimibe/simvastatin in urine. As a potential application, the proposed method was applied to determine the concentration of selected analytes in patient plasma and urine samples after medication and satisfactory results were achieved. In comparison with reference methods, the CA–HF–SLPME–HPLC–DAD method demonstrates considerable potential in the biopharmaceutical analysis of selected drugs.     

Multiple positive solutions for Schrödinger‐Poisson system involving singularity and critical exponent

In this paper, the existence and multiplicity of positive solutions is established for Schrödinger‐Poisson system of the form where 0 ∈ Ω is a smooth bounded domain in , , and λ > 0 is a real parameter. Combining with the variational method and Nehari manifold method, two positive solutions of the system are obtained.     

The spectral analysis and exponential stability of a bi‐directional coupled wave‐ODE system

In this paper, an unstable linear time invariant (LTI) ODE system is stabilized exponentially by the PDE compensato—a wave equation with Kelvin‐Voigt (K‐V) damping. Direct feedback connections between the ODE system and wave equation are established: The velocity of the wave equation enters the ODE through the variable v_t(1,t); meanwhile, the output of the ODE is fluxed into the wave equation. It is found that the spectrum of the system operator is composed of two parts: point spectrum and continuous spectrum. The continuous spectrum consists of an isolated point , and there are two branches of asymptotic eigenvalues: the first branch approaches to , and the other branch tends to ?∞. It is shown that there is a sequence of generalized eigenfunctions, which forms a Riesz basis for the Hilbert state space. As a consequence, the spectrum‐determined growth condition and exponential stability of the system are concluded.     

Electrochemical Monitoring of Methotrexate Anticancer Drug in Human Blood Serum by Using in situ Solvothermal Synthesized Fe3O4/ITO Electrode

Here, we reported on a one‐step fabrication of magnetite Fe₃O₄ nanoparticles/indium tin oxide (ITO) electrode based on the direct growing of Fe₃O₄ nanoparticles on the ITO surface by using a solvothermal process. The modified electrode was used as electrochemical methotrexate (MTX) biosensor with high sensitivity based on cyclic voltammetry and square wave voltammetry techniques. The results demonstrated a linear relationship between the MTX concentration and its oxidation current peak over a wide range from 10^?5 to 10^?14 mole/L with a limit of detection of 0.4×10^?15 M based on the square wave voltammetry (SWV) technique. In addition, Fe₃O₄/ITO electrode showed a good capability for measuring very low concentrations of MTX drug dissolved in human serum solution. Also, Fe₃O₄/ITO electrode was used for detecting MTX in blood serum samples collected from patients after their treatment with MTX. The prepared electrode showed the higher sensitivity that higher than the Viva‐E instrument, which opens the door for developing a cheap, simple and higher sensitive MTX sensor.     

Highly Sensitive AdSV Method for Fe(III) Determination in Presence of Solochrome Violet RS on Renewable Amalgam Film Electrode

The new DP AdSV method for high sensitive Fe(III) determination in the presence of Solochrome Violet RS was developed. The use of an innovative renewable amalgam film electrode Hg(Ag)FE allowed to obtain high sensitivity and significantly minimize the mercury consumption. The best results were obtained for surface area of Hg(Ag)FE equal to 11.8 mm². Instrumental parameters were optimized. The optimal results were obtained using differential pulse technique for the following values: sampling and waiting time ts=tw=10 ms, step potential Es=5 mV, pulse amplitude ΔE=50 mV. Measurements were conducted in 0.05 M acetate buffer (pH 5.6), the concentration of SVRS was equal to 5 μM. Deposition step was carried out at the potential ?400 mV for 20 s. Calculated detection limit for 40 s preconcentration time was equal to 1.4 nM (78 ng L^?1). The influence of the common in environment, organic and inorganic interferences was studied. The developed method for Fe(III) determination was successfully applied and validated by investigation of certified reference material SPS‐SW2 Batch 118 and recovery of Fe(III) from various spiked samples as snow, tap water and bottom sediments. The repeatability (for 50 nM of Fe(III)) of the developed method expressed as CV was equal 3.1 % (n=5).     

Precise Synthesis of Poly(thioester)s with Diverse Structures by Copolymerization of Cyclic Thioanhydrides and Episulfides Mediated by Organic Ammonium Salts

The precise synthesis of poly(thioester)s with diverse structures is still a significant challenge in the polymeric materials field. Herein, we report a novel approach to the synthesis of well‐defined poly(thioester)s by the controlled alternating copolymerization of cyclic thioanhydrides and episulfides induced by simple organic ammonium salts. Both the cation and anion have strong effects on the copolymerization. [PPN]OAc ([PPN]=bis(triphenylphosphine)iminium) with a bulky cation was proven to be efficient in initiating this polymerization, yielding poly(thioester)s with a completely alternating structure, controlled molecular weight, and narrow polydispersity. The poly(thioester) obtained from succinic thioanhydride and propylene sulfide is a typical semicrystalline material, possessing a high refractive index of up to 1.78. Because it uses readily available monomers, this method is expected to open up a new route to poly(thioester)s with diverse structures and properties.     

Selective Decrosslinking in Liquid Crystal Polymer Actuators for Optical Reconfiguration of Origami and Light‐Fueled Locomotion

The ability to optically reconfigure an existing actuator of a liquid crystal polymer network (LCN) so that it can display a new actuation behavior or function is highly desired in developing materials for soft robotics applications. Demonstrated here is a powerful approach relying on selective polymer chain decrosslinking in a LCN actuator with uniaxial LC alignment. Using an anthracene‐containing LCN, spatially controlled optical decrosslinking can be realized through photocleavage of anthracene dimers under 254 nm UV light, which alters the distribution of actuation (crosslinked) and non‐actuation (decrosslinked) domains and thus determines the actuation behavior upon order‐disorder phase transitions. Based on this mechanism, a single actuator having a flat shape can be reconfigured in an on‐demand manner to exhibit reversible shape transformation such as self‐folding into origami three‐dimensional structures. Moreover, using a dye‐doped LCN actuator, a light‐fueled microwalker can be optically reconfigured to adopt different locomotion behaviors, changing from moving in the laser scanning direction to moving in the opposite direction.